With the module pivoted, you can reach the plugs from the right hand side and easily disconnect.

The plugs on the module are pointed downwards, but the space is too small to grip the plugs and pull down to disconnect them. After the right hand side nuts are removed you can lift the module off the prongs and pivot upwards. The third nut is loose enough that the SGW module can pivot back and forth. The other (2) on the right hand side can be reached. The left hand side nut is almost impossible to get a socket on. The module is held onto the bracket by (3) nuts. 2.Then connect the FCA 12+8 directly to the 12pin and 8pin (two connectors connected to the SGW) connector on the car. Connection Method: 1.Locate and unplug the 12pin and 8PIN connectors of the SGW module. Your hand must go in, back, and to the left. The Cable Adapter can be used with Autel Maxisys series scanners ,such as MS906,MS906BT,MS906TS,MS908, MS908S, MS908S PRO, Maxisys Elite etc. You can then position the steering wheel upwards so as to reach your arm in at its fullest. The best way to get to it is to take off the lower shrouding of the steering wheel and column (held on by 2 simple screws). On some later model Giulias, the bypass may be in the same location as the previous years:įor the 2020 model year, the module is now placed on the back of a welded bracket, directly behind the steering column. This is not required (the system still functions as intended, but removing it will be less conspicuous).īelow are various instructions, both from customer attempt and factory documentation on the module itself.įOR MY2020+ Model Stelvios, see below. It is recommended to remove the bypass before going in for service/warranty work. Simply disconnect the two connectors running into the SGW module and plug them into the bypass module. NOTE: This SGW Module is located to the right, and just below the steering column. (ALL) Alfa Romeo Stelvio 2.0L (Manufactured 2018+).(ALL) Alfa Romeo Giulia 2.0L ( Manufactured 2018+).This is also required to be used with our Euro+Drive Tuning system for vehicles produced 2018+. This unit is required to access the Body control module, infotainment system and the ECM. The purpose of this module is to prevent CAN bus hacking over the #G or LTE network. This Bypass plug allows you to bypass this module.

Beginning with model years 2018 and above Alfa Romeo/Fiat vehicles are equipped with a new device called a security gateway module.

Autel cable fca fiat